冠磁企業股份有限公司

Crown Ferrite Enterprise Co.

 
中文版

to PC version

     

Ni-Zn EMI Suppression Ferrite Cores

Shield and Toroidal Ferrite Cores

     

Ni-Zn EMI Suppression Ferrite Cores (Shield Ferrite Cores) Ni-Zn EMI Suppression Ferrite Cores (Toroidal Ferrite Cores)

RH & T Series

       

Shield cores (RH series) and Toroidal cores (T series) are the EMI suppression cores with ring shape, to suppress high frequency noise from cables. RH cores are usually used for the cable assembly with plastic injection molding. The smaller RH cores are usually used to pass through beads of other elements or to be inductors by passing through wire. The T cores are mainly used for common mode or differential mode filter to suppression EMI. If the design need higher impedance, increase the wire turns through the core is a fast and easy solution.       

            

 

           

PDF Version : 

          

  

Applications : 

• Suppress high frequency noise from cables to compliance with FCC, VDE and VCCI.
• Suitable for various power / signal cables inside or outside the equipments.
• Widespread use for electric equipments like NB, PC, monitor, printer, digital camera, power supply, DVD player, fax machine, medical equipment, internet wire, and etc.

     

Ni-Zn EMI Suppression Ferrite Cores (Shield and Toroidal Ferrite Cores) Application

   

  

Core Dimension List : 

Ni-Zn EMI Suppression Ferrite Cores (Shield and Toroidal Ferrite Cores) Dimension List

 

     

Reference Information : 

1. Material & Impedance

We have many different materials can be choose but the most popular material is L92 (ui 1500) and L52 (ui 650). High ui core can get higher impedance in lower frequency but will not increase nonstop. For example, ui 1500 core (the red line) is higher than other two cores at 10MHz, but ui 50 core (the green line) get the highest impedance at 100MHz. As the figure, higher ui core with more average impedance in wide frequency range but not as high as the lower ui core at 100MHz. You can choose the material depends on your application.

  

Ni-Zn EMI Suppression Ferrite Cores (Shield and Toroidal Ferrite Cores) Material  vs Impedance

 

 

 

 

 

 

 

 

 

 

2. Test wire condition & Impedance

As the figure, the same core will get different impedance reading with different test wire. Our standard test wire is a diameter 1.0mm with 10cm length wire through the core to compare the impedance for reference. For actually application, the wire length and diameter is different and impedance reading will not the same.

  

Ni-Zn EMI Suppression Ferrite Cores (Shield and Toroidal Ferrite Cores) Test wire condition vs Impedance

 

 

 

 

 

 

 

 

 

3. Wire Turns & Impedance

If the impedance is not enough, consider to increase the wire turns, change a longer core or increase the core quantity is the solution. As the figure, increase wire turns is much better than increase the core length and more economical. But sometime it difficult to increase turns because the wire diameter is too big or the appearance problem. In such a case, increase the core length or change a bigger core is another solution.

  

Ni-Zn EMI Suppression Ferrite Cores (Shield and Toroidal Ferrite Cores) Wire Turns vs Impedance 

      

  

Copyright 1999-2019 Crown Ferrite Enterprise Co.

www.cfe.com.tw       cfe@cfe.com.tw